Layer: 0.2 mm
Extruder: 0.4 mm
Build Volume: 90 x 145 x 3,2 mm
2 x webbing or any other strap: string, silver-tape, length: about 80 cm
Piece of thick, soft fabric: spacer fabric, sponge, foam, neoprene, etc. about 12 x 15 cm
3D printer with heated table or heat gun
Optional: clamp & regulator
In printing, avoid bright colors of filament !
3D prints must not attract attention, they are to help people in combat conditions.
If you don’t have other materials, remember to paint them with any paints.
Do not send / give anyone failed 3D prints
There is no point in donating 3D prints that those in need will not be able to use. Look out for structural weaknesses and any major distortions.
Any 3D printing material is good
Unless otherwise noted in the description, models can be 3D printed from PLA, ABS, PET-G, ASA and other printing materials.
The more, the better
If you have the ability to not only 3D print, but also assemble a finished solution from it – DO IT. Any kind of help is priceless.